Skills:
I) Process Operations: Maintained a high level of safety wearing proper PPE, such as hardhats, boots, safety glasses and chemical-resistant rubber gloves, when applicable Set, adjusted and monitored automatic process controls to regulate temperature, pressure, level and flow variables in compliance with operating procedures on the outdoor Hands-On-Training skid at LMC Troubleshooting with an understanding of P&IDs, flow diagrams, historical trends, material balance, process indicators and controls, and related principles of physics Thorough operation of the En Vision Operator Training Control Room Simulator with the use of tutorials, start-ups, shutdowns and troubleshooting scenarios Applied Instrumental Analysis Lab: basic use of analytical procedures, such as concentration conversions, spectroscopy (Hach Colorimeter, Atomic Absorption and Infrared), meters (pH, Conductivity and Salinity) and chromatography Knowledge of 29 CFR 1910: Occupational Safety and Health Standards, with emphasis on Process Safety Management, Personal Protective Equipment, Hazard Communication and Hazardous Waste Operations and Emergency Response. II) Do-it-yourself projects: Safe and proper use of power and pneumatic tools, including saws, drills, sanders, nail guns, paint sprayers and grinders while maintaining a high level of safety wearing proper PPE (boots, safety glasses/shield and leather gloves) Partnered with a fellow Homeowner's Association board member to replace all outside lighting and improve drainage Installed new interior doors and hand-chiseled the hinges; also crown molding, casing and new baseboards Microwave oven repair and new toilet installation